Security Systems and Surveillance

The New AX-100TFR and AX-200TFR from OPTEX is a Revolution in the perimeter security industry, offering a significant cost saving alternative to a traditional hardwired system. No trenching is required, drastically reducing installation costs. The unit comes wireless ready with a multi functional back box and is compatible with most manufacturers wireless systems. The AX-TFR series comes with four 3.6V batteries, with an avg. lifespan of 5 years on the 100ft model and 3 years on the 200ft model. Features: Significant cost saving alternative to traditional hardwired systems; Long battery life (Approx. five years for the 100TFR and three years for the 200TFR); Low battery output and LED (Separate wireless transmitter is required to monitor); Works with most manufacturers wireless system; D.Q. circuit (environmental disqualification); IP 55 rated.

Dual sensor contains both a photoelectric and ionization sensor providing dual sensor protection in your home Hush feature temporarily silences nuisance alarms Battery backup provides protection even during a power outage Red LED flashes every 30-40 seconds to indicate that the smoke alarm is operating properly Test/Reset button tests units electronic circuitry and horn, Manufacturer: Kidde

The DSC WS4916 smoke detector has a few built in features including, integrated heat detector ( 135 degree ), an integrated 85db siren, a local test button, and a low battery detector. The 4916 has an average battery life of four years.

Features include: Photoelectric sensor, which is more effective at detecting smoldering fires, that smolder for hours before bursting into flame. 120V VAC inter-connectable (with maximum 11 compatible devices). Power indicators show which unit in the series initiated the alarm. Quick plug-in power connector for easy installation. 9V battery backup for peace of mind during power malfunction. Optipath 360 technology allows 360 access to the layer of air on the ceiling or wall that carries the fire signatures (smoke, combustion particles, and volatile components). Single test/silence button which both silences a nonthreatening alarm or low battery warning and allows you to test the unit s functionality. Locking feature for tamper resistance. 10 year limited warranty. Vermont and Oregon approved.

AX-500PLUS. Built to take the worst. With over 14kV surge protection, impact resistant covers, and more than 99% beam tolerance, these detectors withstand the most severe environmental conditions. Extra large dual beams are used to provide the greatest protection against false alarms caused by birds, falling leaves, and other disturbances. These beams have everything you need for a quality installation, including a form C relay and Conduit knockouts, as well as optional heaters, back covers, and beam towers.

First Alert ONELINK battery operated wireless smoke alarm Uses photoelectric sensing technology which is environmentally friendlier Simple to use silence/test button Low battery warning and convenient pullout battery drawer Includes 2 AA batteries and comes with a 10 year warranty, Weight: 1 lbs., Manufacturer: First Alert

Optex full-featured 100' Dual Photoelectric Beam. The industry's most full-featured short range photobeams. 'Finger-Touch' alignment controls and precise beam definition combine with gun-sights and voltage meter jacks to make installation easy. A weatherproof (IP55) housing applies rubber ''O'' rings to keep out insects and dirt. Lightning protection exceeding 14kV, form C relay. Optional heaters and back covers are available.

2-Wire Fast Response Photoelectric Smoke Detector w/Remote Alarm/Trouble LED, 1 Set of Literature Per Box, Not Individually Packaged. S10A Compatible, 10-Pack

AX-250PLUS Built to take the worst. With over 14kV surge protection, impact resistant covers, and more than 99% beam tolerance, these detectors withstand the most severe environmental conditions. Extra large dual beams are used to provide the greatest protection against false alarms caused by birds, falling leaves, and other disturbances. These beams have everything you need for a quality installation, including a form C relay and Conduit knockouts, as well as optional heaters, back covers, and beam towers.

No Description

Add-on wireless smoke sensor for SecurityMan Air-Alarm system Wireless Transmitting Distance: ¿300ft (in open area) Operating power: 9V alkaline battery Battery service life: ¿ 2 years Monitoring range: 20m2

No Description

No Description

No Description

The SCO5B is a basic battery operated photoelectric smoke/CO combo alarm meets most state and local codes for carbon monoxide and combination alarms. Combo alarms protect against two deadly threats, smoke and carbon monoxide.

No Description

The InnovairFlex D4120W watertight 4-wire photoelectric duct smoke detector is UL listed as a watertight enclosure providing protection against falling dirt, rain, windblown dust, splashing and hose directed water. D4120W duct smoke detector features a pivoting housing that fits various applications: both square and rectangular footprints mount to round or rectangular ductwork.

This is a photoelectric single station smoke detector designed to give reliable early warning of the presence of smoke where both audible and visual alarms are required. It has a pulsing LED light source and a photodiode sensor in a fully screened sensing chamber. When smoke enters the chamber, the infrared beam is deflected onto the sensor. The LED rate increases to eight times the normal pulse rate. After the photodiode confirms the presence of smoke for two consecutive pulses, it will produce the signal necessary to trip the audible and strobe light alarms.

No Description

Battery-operated smoke alarm with photoelectric sensor. With convenient silence/test button, blinking power light, 85-decibel alarm.

Optex AX-350TF 350' Outdoor Dual Beam Set/Selectable Channel (used for Multi-Stacked Beams) (Compatible with MKII series) . Optex specializes in passive and active infrared technology, control systems, and CCTV products which are applied in the fields of Security, Automatic Door Controls, and Factory Automation.

The Optex AX-200TF provides exceptional photoelectric detection in a housing designed to meet extreme conditions. The ideal optical pitch design reduces false alarms due to accidental beam interruption by falling leaves, birds, and other natural phenomena. These features deliver performance with higher reliability in severe outdoor environmental conditions. The unit's selectable beam frequencies can be used to avoid unwanted crosstalk that can occur when using multiple photobeams over long distances or for beam stacking applications.The AX-100TF features the highly durable IP65 casing, which prevents water, dust or bugs from getting into the unit. An anti-frost hood prevents frost forming on lower beams. The cover's flat front makes maintenance and cleaning easy.For a beam unit to go with the AX-200TF please see the Optex AX-200Plus.Also available in 100 foot range.

Ideal for: Kitchens, Hallways, and Bathrooms Escape light illuminates your path to safety, Manufacturer: First Alert

Kidde KID9000102 When every second counts, you`ll have your warnings spoken to you in a loud-volume voice: Fire, Fire! or Warning! Carbon Monoxide! Two-alarm system also announces Low Battery when batteries need changing. Also includes chirp signal, flashing LED and test/reset button. Uses three AA batteries (included). Power Source(s): 3 AA; Mounting: Universal Mounting Bracket; Quantity: 1 each; Compliance, Standards: UL Listed.

Optex AX-200TFR 200' Outdoor Photoelectric Wireless Ready (batt.incl.) Set Selectable Channel (used for Multi-Stacked Beams) . Optex specializes in passive and active infrared technology, control systems, and CCTV products which are applied in the fields of Security, Automatic Door Controls, and Factory Automation.

No Description

SILENT KNIGHT SD505-ADH 2 WIRE ADDRESSABLE DUCT SMOKE DETECTOR ONE NEW IN OPEN BOX SILENT KNIGHT SD505-ADH 2 WIRE ADDRESSABLE DUCT SMOKE DETECTOR FOR USE WITH SILENT KNIGHT'S SD505-APS PHOTOELECTRIC SMOKE DETECTOR AND SD505 AIS IONIZATION SMOKE DETECTOR (BOTH ARE SEPARATE PURCHASES) THE SD505-ADH ANALOG ADDRESSABLE DUT SMOKE DETECTOR DETECTS SMOKE AND PRODUCTS OF COMBUSTION PRESENT IN AIR MOVING THROUGH AN HVAC DUCT TO PREVENT RECIRCULATION OF SMOKE INTO THE AIR HANDLING SYSTEM. THE SD505-ADH IS A HEAVY DUTY METAL HOUSING WITH A PRE INSTALLED DETECTOR BASE. WHEN SMOKE IS DETECTED IN A DUCT, THE UNIT COMMUNICATES THE CONDITION TO THE CONTROL PANEL. THE PANEL IN TURN, DEPENDING ON PROGRAMMING, TURNS OFF FANS, BLOWERS AND OTHER DEVICES SOLD NEW IN OPEN BOX AS PICTURED NEVER USED

Wireless technology uses radio frequency to both transmit and receive messages about a hazard in the home Battery powered enables homeowners to install interconnected smoke alarms in existing homes without rewiring Smart touch button quickly and temporarily silences nuisance alarms activated by any alarm in the system Wireless alarm can be installed in a detached workshop or shed to work with your interconnected system UL Approved, Weight: 1 lbs., Manufacturer: Kidde

AX-500PLUS. Built to take the worst. With over 14kV surge protection, impact resistant covers, and more than 99% beam tolerance, these detectors withstand the most severe environmental conditions. Extra large dual beams are used to provide the greatest protection against false alarms caused by birds, falling leaves, and other disturbances. These beams have everything you need for a quality installation, including a form C relay and Conduit knockouts, as well as optional heaters, back covers, and beam towers.

Smoke And Carbon Monoxide Alarm, Detection Method Photoelectric, Up To 24 Units Interconnection Capability, Power Source 120vac, 9v, Audible Alert 85db @ 10 Ft., Horn, Visual Alert Red Led, Diameter 5-3/4 In., Height 1-7/8 In., Width -, Digital Readout No, Battery Backup Yes, Features Interconnectable, Green Power Led, Red Alarm Status Led, Quick Connect Power Harness, End Of Life Alarm, Voice Warning, Hush Button Yes, Locking Pin Yes, Operating Temp. 40 To 100 Degrees F