Security Systems and Surveillance

The FireLite MS-2 and MS-2E Fire Alarm Control Panels (FACPs) bring the latest in microprocessor technology to conventional fire controls. The MS-2 is compatible with the i³(TM) smoke detectors from System Sensor with drift compensation, maintenance alert, and freeze warning. Automatic synchronization of audio/visual devices with three selections for manufacturer protocol. The Notification Appliance Circuit (NAC) protocol can silence audible devices while strobes continue to flash, using a single pair of wires. The MS-2 is compatible with conventional input devices such as two- and four-wire smoke detectors, pull stations, waterflow devices, tamper switches and other normally-open contact devices.

The first stand-alone INSTEON USB-based home automation interface with mControl software for controlling lights, appliances, heating/air conditioning systems and alarm systems.

The indoor/outdoor 3 phase power simplex control panel is a NEMA 4X waterproof thermoplastic enclosure. It includes an audible alarm, silence switch, red alarm light, an alarm float and two control floats. Floats have 20' cords. An "HOA" switch offers either hand (manual), off or automatic operation. 2.5 - 4 amps. 22.00 L. 19.00 W. 9.35 H.

Norstar Door Opening Controller:Equipped with the Door Opening Controller (DOC), the Norstar doorphone allows the occupant to unlock electric doors simply by pressing an OPEN softkey display button or a dial pad digit on their Norstar set. In addition, because the Doorphone with the DOC enables electronic devices to be controlled through contact closure (third party supplied), dial pad digit commands from a Norstar telephone allows a building occupant to remotely activate alarm systems, surveillance cameras, lights, etc. Each Doorphone can communicate with up to twelve DOCs, providing control of up to twelve electrical devices through the telephone dial pad.

No Description

Tripp Lite s SNMPWEBCARDTAA is compliant with the Federal Trade Agreements Act (TAA) for GSA Schedule purchases. The SNMPWEBCARDTAA allows network users to operate any expansion slot-equipped Tripp Lite SmartPro or SmartOnline UPS as a managed device on the network. Enables remote monitoring and control of UPS and site electrical conditions using the SNMP network management platform or a web browser. Provides remote viewing of site electrical data, UPS status information and self-test logs. Supports selective rebooting of locked network equipment without disrupting power to other devices when used with customized load management receptacles available on select Tripp Lite UPS systems. Optional ENVIROSENSE module provides remote temperature/humidity monitoring and a dry contact interface to control and monitor alarm, security and telecom devices.

With the DSC self-contained wireless alarm system (PowerSeries 9047), you get a full-featured home security solution that installs in minutes and eliminates the clutter and expense of pulling wire to a host of sensor and detector accessories. Not only does this help installers move to the next installation quicker helping to increase revenue but it provides them with the flexibility needed during system placement. The wireless device enrollment process allows items such as smoke detectors, motion detectors and door/window contacts to be easily integrated.

You know that you live in violent time's right? You need to make sure that you have the best security possible for your home, or business. There are many different types of alarm kits that you want to research, but one of the better ones is the Ademco Vista Alarm Kit. This alarm kit is the perfect solution for residential or commercial installation. It offers hardwired expansion, graphic keypad support, two-wire smoke detectors, scheduling options and a host of user features. Plus this kit gives you the most panel for your dollar. You will get six on-board hardwired zones standard; its plethora of options, expandability, and scheduling that make it powerful enough to meet even the most demanding requirements for security. Having the best security possible is the only way that you will be able to deter burglars so that you don't become their next victim.

Kit contains: 120-Volt AC ionization smoke and fire alarm USI-1213, USI-960 relay and 177 candela power strobe model USI-2177 120 VAC operation. Interconnectable with other USI wired-in smoke or carbon monoxide alarms. Ideal for residential, institutional, hotels motels dormitories and multi-family installations The strobe maintains a constant 1Hz flash rate providing hearing impaired individuals with smoke alarm warning Meets and exceeds the ADA (Americans with disabilities act) requirements UL listed components, Manufacturer: Universal Security Instruments

Photos are for reference only. Please read item title carefully as the manufacturers part number is the item you will receive.

With its uncompromising technology, reliability and self-contained architecture, Honeywell's LYNX Plus is an easy-to-install, self-contained system. LYNX Plus is a combination control panel, keypad, siren, dialer, two-way voice system and speakerphone in one.

The FireLite MS-4 and MS-4E Fire Alarm Control Panels (FACPs) bring the latest in microprocessor technology to conventional fire controls. The MS-4 is compatible with the i³(TM) smoke detectors from System Sensor, with drift compensation, maintenance alert, and freeze warning. Automatic synchronization of audio/visual devices with three selections for manufacturer protocol. The Notification Appliance Circuit (NAC) protocol can silence audible devices while strobes continue to flash, using a single pair of wires. The MS-4 is compatible with conventional input devices such as two- and four-wire smoke detectors, pull stations, waterflow devices, tamper switches and other normally-open contact devices. Refer to the FireLite Device Compatibility Document for a complete list of compatible devices. Note: Unless indicated otherwise, the term "MS-4" refers to both MS-4 and MS-4E models.

Relay Module, Smoke Alarm, Provides Interconnection Of Devices, For Use With Kidde Smoke Alarms, Height 3/4 In., Length 3 In., Width 1-3/4 In., Power Source 120vac, Operating Temp.

No Description

Altronix ACM8CBE distributes one (1) 12 to 24 volt AC or DC input over eight (8) independently controlled class2 power limited circuit breaker protected outputs. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. It will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both fail-safe and fail-secure modes. The ACM8CBE is designed to be powered by one common power source which will provide power for both the board operation and locking devices, or two totally independent power sources, one (1) providing power for board operation and the other for lock / accessory power. The FACP Interface enables Emergency Egress, Alarm Monitoring, HVAC Shutdown, Elevator Recall or maybe used to trigger other auxiliary devices. The fire alarm disconnect can be configured for the following mode

The most versatile NetworX control available, the NX-8E offers 4-192 zones. Ideal for home automation to medium-sized commercial installations, the NX-8E is flexible enough to meet the most demanding applications.

5820XL is an intelligent addressable fire alarm control panel (FACP). The basic 5820XL system can be expanded by adding modules such as 5860 remote annunciator, 5815XL signalling line circuit expander, 5824 serial/parallel printer interface module (for printing system reports), and 5895XL intelligent power module. 5820XL supports Hochiki or SK devices. 5820XL also features a powerful built-in dual line fire communicator that allows for reporting of all system activity to a remote monitoring location.

The GSMVLP is an optional communication module intended for use with Lynx Plus Series Series controls, and provides wireless communication with the AlarmNet network for backup delivery of alarm and other messages to the monitoring central station. It also supports voice communications between the control panel and the Central Station.

No Description

Product Features: Connection Center and Module Type: Alarm Boxes; Security/Surveillance Type: Connection Centers and Modules

The GSM-200 is a cellular communication module that connects the PowerMax(R)Pro system to the alarm central station. The module can report via GPRS data channel and/or through the GSM network. This enables a high-speed and highly-reliable communication channel in cases of line failure or tampering with the standard telephony lines. In addition, it supports remote operation and event reporting via SMS.

This is for a Telular Telguard Cellular Alarm Transmission System, model T-1610M , part number 56013501.This item is new old stock. Telguard comes complete with a cellular transceiver (without handset), antenna, dialer-to-cellular interface with integrated control and power module and plug-in transformer. All components are mounted in a compact metal enclosure with key-lock. The Telguard family of cellular alarm transmission systems enable any host control/communicator (C/C) to send its alarm s

SquareTrade © AP6.0 THIS AUCTION IS FOR ONE RADIONICS D7212B1 CONTROL COMMUNICATOR COMMAND CENTER! Manufacturer: RADIONICS Our Part Number: RADD7212B1 Catalog Number: D7212B1 Ships Within: 12-24 Hours Condition: NEW IN BOX Combined Shipping: NO Spec Sheet: CLICK HERE Retail Price: N/A Qty: 1 Made By RADIONICS The D7212 is a central control panel capable of monitoring alarm points for intruder or fire alarms while operating user command centers, and other outputs. The D7212 includes a built-in

No Description

The GSMVLP5 is an optional communication module intended for use with Lynx Touch Wireless Alarm Kit controls, and provides wireless communication with the AlarmNet network for backup delivery of alarm and other messages to the monitoring central station. It also supports voice communications between the control panel and the Central Station.

Product Features: Status Change Detector Type: Smoke Detectors; Technology: Wireless; Security/Surveillance Type: Connection Centers and Modules, Status Change Detectors

Great Lakes Variable Speed Fan Controller Local Input 125 or 250V No Circuit Breaker Dual A/C input – (2) C14 IEC -auto-switching in event of power failure 90-264 Volt auto-sensing RJ-45 Ethernet connection Access via web browser Direct connection available via crossover cable Four RJ jacks for connection of up to 4 remote temperature sensors Fan speed manual/local override via rotary switch – unplug ethernet connection Set point change button must be pressed while activating rotary switch Rotary switch with recessed screwdriver slot Manual temperature set-points of 65-100 degrees F Manual full on setting for 100% fan speed Plug and Play—no client software required Remote Input – Three Levels of Password Protection Temperature set-points of 65-100 degrees F Optional full on setting for 100% fan speed Friendly device and sensor names Fahrenheit or Celsius selection Low and high trip level selection Alarm notification selection SNMP trap, e-mail and/or audible buzzer Local Output Three C13 IEC outlets for AC fan connection, 267 watts per outlet Fan speed control of 30-100% Fans start on full speed for 1 second and then adjust to the necessary speed to maintain set point temperature Scrolling digital display of real-time measurements Set point temperature Internal temperature Four external temperature Fan speed percentage Audible alarm with silence reset button Fan running visual indicator LED’s Speed – running at a Level less than full Full On – orange LED Fan manually off – orange LED Remote control – orange LED Fan Full on – orange LED Over temp – red LED Remote Output Real-time measurements and graph Set point temperature Internal temperature Four external temperatures Fan Speed Log data available for export via XML or real-time via SNMP Event log with variable content settings Visual image display from optional IP addressable camera

Temperature Controller, Digital, Universal Programmable Sensor Type, Input Voltage 90 To 250 Vac, Length 3.75 In, Width 1.87 In, Depth 3.12 In, Control Mode Pid, Dual Red Led Digital Display, 2 Relay Output, 1 Relay Alarm, Din Type 1/8, Output Relay 2a, Power Consumption 12va, Based On Input, Standards Ul, csa, ce

No Description

ELEC RIM DEVICE NO DOGGING ALARM MODULE SIGNAL SWTCH