Building Supplies

Southwest Windpower 45 Foot Tower Kit AIR-X or BREEZE Wind Generators Why an AIR Tower? No concrete No winching No sweat! Kit includes: Base Connector Upper Wire Set (280 ft. pre-cut) Lower Wire Set (160 ft. pre-cut) (2) Base Staples (3) 3/8" x 1 ½" Bolt (3) 3/8" Locknut (8) Cable Thimbles (16) Cable Clamps 1* Set Up Kit * Note: This 45 foot Tower Kit includes a setup kit to raise the tower. If more than one tower is to be erected, a single setup up kit can be used for any towers to be installed. See below for kit details. Setup Kit includes: Gin Pole Cap 100 Foot Rope 8 Foot Cable 3/8" x 1-1/2" Bolt 3/8" Locknut Pipe Pieces Needed: (available at fence suppliers) 24 foot (7.2 meter) length for tower 21 foot (6.3 meter) length for tower 6 foot (1.8 meter) length for tower base 21 foot (6.3 meter) length for gin pole Pipe Requirements Tower Kits use 1-7/8 inch (47.5 mm) Steel Tubing Maximum Wind Speed Maximum Wind Speed 70 mph 80 mph 90 mph Recommended Wall Thickness .065 inch (1.65 mm) .090 inch (2.3 mm)

You are bidding on one 1 1/2"locking collar and 1 1/2" nylon washer Fits 1 1/2" tower pipe. Inside dimensions of the collar 1 15/16" Fits pipe with 1 7/8" outside diameter The picture below is for illustrative purposes only. Collar has one heavy duty set screw. Picture below shows 2 set screws. Only comes with one. Watch the video below to see how it's used. See all my how to wind and solar videos at

YOU ARE BIDDING ON ONE 70 AMP 1000 VOLT 3 PHASE BRIDGE RECTIFIER KIT FOR PERMANENT MAGNET ALTERNATORS (PMA'S) WIND TURBINES CONTINUOUS DUTY REPLACE THE ORIGINAL AUTO TYPE RECTIFIER WITH THIS ONE! THIS IS THE HIGHEST AMPERAGE ON THE MARKET TODAY ! AND ONLY BY MISSOURI WIND AND SOLAR THE LEADER IN WIND AND SOLAR good cooling capabilities. Can handle 80 amps continuously using air cooling, no fan. works on all AC output wind turbines that produce 70 AMPS or less Use self tapping screws or the spade terminals to connect your wires . Operating range is 0 to 1000 Volts. Two mounting holes for easy securing KIT CONTAINS .1- 70 amp, 1000 volt rectifier .1- 3 pin, 12 gauge harness .6- ring terminals .3- splices .5- self taping screws Diamensions- 3 7/8" long x 2 3/8" wide x 1 1/8" thick The pictures below show a Suzlon wind turbine in Denmark with a Missouri Wind Turbine mounted on top.Suzlon made it clear they needed dependable wind turbines to operate the beacons. After months of testing they decided to go with a win

Mountain Wind Trading Company you are bidding on one mounting bracket for a pma This is the same mounting bracket we